
Trek 609E-6
High Voltage Amplifier for Industrial and Research Applications, Output Voltage 0 to ±4 kV DC or Peak AC
Advanced Energy’s Trek 609E-6 high voltage amplifier features a four-quadrant output and low-noise operation.
- Output Voltage: 0 to ±4 kV DC or Peak AC
- Output Current: 0 to ±20 mA DC or Peak AC
- Slew Rate: Greater than 150 V/μs
- Large Signal Bandwidth: DC to greater than 13 kHz (-3 dB)
- Gain: See datasheet
Tải Catalog
The DC-stable Trek® 609E-6 high-voltage amplifier is used for electrostatic chucks, mass spectrometers, and various other industrial and research applications. Its low-noise operation, extensive bandwidth, and high slew rates are backed by an all-solid-state design. And you can wire different input configurations into the unit. Configure as non-inverting, inverting, or differential.
Built for Demanding High Capacitive and Reactive Loads
The Trek 609E-6’s four-quadrant, active output stage sinks or sources the current into reactive or resistive loads throughout the output voltage range. This is essential for the accurate output responses and high slew rates demanded by a variety of loads.
Benefits
Drive capacitive loads via a four-quadrant output
Enable high accuracy thanks to a closed-loop system
Safeguard equipment with short-circuit protection
Take advantage of low-output noise and ultra-accurate outputs
Features
Dynamic adjustment optimizes the AC response for various load parameters
NIST-traceable calibration certificate provided with each unit
DC-stable for programmable supply applications
Local and remote high voltage On/Off capabilities
Switch selectable for current limit or trip